“If turret will not stop” error (TOE)

If the turret will not stop
The turret indexing motion is stopped by the pre-indexing pin, which is pushed down by the pre-indexing solenoid. The solenoid is energized by the strobe signal (by means of a relay) of the encoder (see : “How to set the encoder” section ).

1st: Make sure that a strobe signal is coming from the encoder. Check the relay of the pre-index solenoid.

2nd: Check the pre-index solenoid with 24VDC (which you can get from the brake circuit). If the pin of the solenoid is not moving freely, use some lubricant (WD40).